Sega-Naomi

Hi...

a question....can i use the CPS 3 Kick harness also for the Sega I/O board...is it the same?



Thanks.

Which I/O are you referring to? Sega I/O versions A,B & 2.0 use a single row connector. The dedicated, non-jamma I/O uses pins and connectors similar to what computer hard drives use. The Capcom I/O already has the CPS3 connector on it:



<---As seen here.

Hi Joshua..

yes i see that the Capcom I/O Board have so an CPS3 connector...

But i have a Sega I/O Board Rev. B and need a Kick harness to connect with it...but i dont find one.. :smt013 :smt011

If I remember correctly, you can use either a CPS1 or Mortal Kombat kick harness if you can't find the Naomi type.

Ok thanks very much....

Or i need a Capcom I/O Board...

svensen79 wrote:Ok thanks very much....

Or I need a Capcom I/O Board...

Di you get any of the suggested kick harnesses ? I'm looking for one aswell and want to know if they worked

Hi Vipertje...

I found an orginal Sega I/O Board Kick harness and it works fine...

I have one of the Sega I/O boards too.

http://www.sega-naomi.com/resources/manuals/NaomiWD.pdf

If I understand this diagram correctly, the single-row14-pin set at the top of the I/O board in the diagram are what I need for the kick buttons?

The pinout on the CPS1 SF2 harness looks similar, but I can't tell if its what I need.

http://www.jammaboards.com/store/sf2-ki ... od_48.html

Really I just need the right connector/pins and I could even wire my own harness...

Maybe someone else with more experience on the Sega I/O board can offer their wisdom? I would really like to get my setup up and going. Thanks.

I can make these for you all.



?6 plus P&P Either PP Gift or +4%



PM if interested



John

Just to clarify a bit, here is what I am working with:

http://triplemoonstar.brinkster.net/seg ... ockid=1854



Still going by the diagram. I need a 1x14 kick harness to plug in here where I highlighted:



Anyone? Thanks