Page 2 of 3
Posted: Tue Jul 28, 2009 5:23 am
by OldFoo
ok it's good , not problem dimm 0 .
you are the error 24 now ??
your GDDrive is conneceted, the CD Spining ?
if you have a dreamcast, replace the lens of the dreamcast in the GDrom drive and test it .
Warning : please take take your time for connect the alimentation, if you plug the alimentation in the bad sens, your lens is destroy and possibility of error 24 !!!!!!!!
Posted: Wed Jul 29, 2009 12:25 am
by OldFoo
forgive me, but what do you mean by alimentation?
Posted: Wed Jul 29, 2009 1:15 am
by OldFoo
I believe that is supposed to mean 'supply'. He may be referring to the power connector since the I/O and GD connectors look the same, but are connected differently. If you mix them up, you will blow one of the pcb's.
Posted: Wed Jul 29, 2009 1:19 am
by OldFoo
Is there a photo posted anywhere showing what I should be doing?
Posted: Wed Jul 29, 2009 4:08 am
by OldFoo
Just use the large picture above as a reference. The GD-ROM power connector is clearly shown. :smt110
Posted: Wed Jul 29, 2009 5:20 am
by OldFoo
sorry for my english
exactly, the alimentation is the power supply !!!!!
use the big picture , the connector and the GDRom drive is show !!!!
Posted: Sun Aug 09, 2009 1:54 am
by OldFoo
Ok- so I got my replacement lens and I have an issue.
I didn't realize there were 2 versions. I have a 610-0617-01
and I got the 610-0617 replacement. So I cannot just swap the unit.
Should I replace the lens assembly, or am I screwed? Looks like the board
is different, the scussi and power inputs are not soldered onto my replacement board. Any suggestions? Am I going to have to transfer the inputs, is that even possible?
Posted: Mon Jan 18, 2010 2:49 pm
by OldFoo
Any updates on this?
I recently purchased a twin initial D Ver2. cabinets, and Player 2 is now getting a ERROR 24 as well. I tried the P2 GD-Rom in the P1 cabinet, and it worked, so I am still at a loss...
Did you resolve yours?
Thanks,
Saloon
Posted: Mon Jan 18, 2010 3:55 pm
by OldFoo
The board was still good on mine. I was able to remove the lens assembly off the board of my replacement and swap it with the lens unit on my defective kit. Works great.
Posted: Mon Jan 18, 2010 4:24 pm
by OldFoo
fantoboy wrote:Ok- so I got my replacement lens and I have an issue.
I didn't realize there were 2 versions. I have a 610-0617-01
and I got the 610-0617 replacement. So I cannot just swap the unit.
Should I replace the lens assembly, or am I screwed? Looks like the board
is different, the scussi and power inputs are not soldered onto my replacement board. Any suggestions? Am I going to have to transfer the inputs, is that even possible?
Lens/motor unit is the same on both versions. You'll have to remove the lens motor unit from your replacement lens unit and place it in your gd-rom drive.