:smt007
This beauty is a custom joystick kit, geared towards arcade cabinets and custom controllers alike.
For JAMMA Support, you must solder on an extension card, that will turn the Wire Inputs you choose into a PCB style "Slide On" Connector.
2 x 10 bit ADC inputs for X, Y axis
1 x 8 bit ADC input for Throttle axis
1 x 8 bit ADC input for Rudder axis
1 x 8 bit ADC input for Slider axis
1 x 8 bit ADC input for Dial axis (Can be set up to 2 more buttons for Dance Games that use Center pads such as PUMP or Technomotion)
1 x 8 position Hat switch (Hat uses 4 button switches, which can be turned into a spare 4 buttons.)
24 buttons (Which can be reassigned to many setups, like a second HAT, coinswitches,, Whatever you need.)
It is also reprogrammable (Shown Prototype is not end user programmable, I'll add it later
)This is the ARCADE PANEL Version of this board, I am producing variants that are geared towards Dance Dance Revolution/In The Groove/Pump/Technomotion systems, AKA Dance Machines.
Note that there are mistakes and this is just a vaporware prototype, I do have a working protoboard mockup, but it looks entirely different from what is shown.