Please answer my noobish question please

OldFoo · Post by **OldFoo** » Mon Jul 21, 2008 6:02 pm

Ok after about a month of waiting my Naomi setup came (yay!) and I hope to try it out after work. However I want to make sure I don't fry anything when I do it. I plan to to plug it up into 1 of two raster standard res cabs with jamma boards and Harnesses. I have a Naomi 1 mobo, Capcom I/O and the cables to hook it up. I'm merely trying to see if the game and board will start up so if you could lend me some advice it would be much appreciated

OldFoo · Post by **OldFoo** » Mon Jul 21, 2008 7:37 pm

Just make sure you flip the dipswitch to display on standard res. You should be just fine :smt020

OldFoo · Post by **OldFoo** » Mon Jul 21, 2008 9:06 pm

yay indeed! I know the feeling..

You should also check if the 5v and 12v lines coming from your JAMMA harness are not too far off base. Since you are already running JAMMA PCB's it should not be a problem, but you can never be too careful.. since it is a nice Capcom I/O and all.. :smt023

OldFoo · Post by **OldFoo** » Mon Jul 21, 2008 11:34 pm

Thx guys

It fired up perfectly :smt020

OldFoo · Post by **OldFoo** » Mon Jul 21, 2008 11:52 pm

Cool! what did you do for stereo sound? just curious :smt020 I dunno too much about the Capcom I/O does it do it?

OldFoo · Post by **OldFoo** » Tue Jul 22, 2008 2:19 am

In terms of stereo input-output, the Capcom I/O only acts as a volume control. It does not have a stereo amp, only a mono amp for the jamma harness.