Naomi Kickharness with Sega I/O

[OldFoo]

HI folks,

I was reading here for some weeks, while I was waiting for my Naomi Board. To Prepare the usual stuffe, wiring, games etc.



I'm using the Naomi on a Blast City Cab with 1st. Revision Sega I/O Jamma - JVS Converter. I bought a Kick Harness that fit's on the I/O of the Blast City for the 6th BUtton of Both Players. Buttons 1-5 are wired on Jamma Harnes.



This is my Setup: [url]https://dl.dropbox.com/u/6371002 ... AG0492.jpg

Kickharnes:

https://dl.dropbox.com/u/63710024/naomi/IMAG0492.jpg



On all Pinout Pictures I found through Google research The Wiring of the Kickharness on the Sega I/O shoud be: Pin 4(P1 B6),8(P2 B6),13 and 14 for GND. Jumper Setting should be on pins 2&3, position B.

For example this one:

https://dl.dropbox.com/u/63710024/naomi/naomijamma.gif





BUT! I always get an error after Loading the Game, CVS 2 2001 that says: https://dl.dropbox.com/u/63710024/naomi/IMAG0489.jpg





My Question is:

Are my "setup's" done correctly? Is my Jumper set riht with pins 2&3 (B)?

And is my Kickharness build right?



I'm in desperate need of help.

[OldFoo]

Check your voltages at the I/O while the system is running. It may be too low for the board to work properly. You should get 5v & 12v. It can be a little above such as 5.1v & 12.2v or something like that.