Sega-Naomi

Hey Guys,



I finally decided to drag Virtua Golf out of storage and hook it up in my uni. I'm getting an error message after it boots that says:



"I/O board connected to Naomi Board does not meet game specs"



I've tried two different dimm boards, two mobo's and all give me the same error. Any help or suggestions would be greatly appreciated.



Thanks!

The Virtua Golf panel has a trackball which has it's own I/O attached underneath the panel. If it is not connected, you will get this error.

joshua3dg wrote:The Virtua Golf panel has a trackball which has it's own I/O attached underneath the panel. If it is not connected, you will get this error.

Yep, that's it, but I do not have a cable in the cab to connect it to. There's one in the bottom of the Uni, but I cannot tell what it attaches to. From the I/O board on the CP, where does the other end of the cable plug into?



Thanks!

It connect via USB connector. You connect the trackball usb to the I/O usb in a chain. The trackball I/O also needs 5v.