Sega-Naomi

HELP! :smt013



I purchased a House of the Dead 2 system, standard upright with a Nanao MS29-32 monitor.



Supposedly the monitor was bad. I had it tested and apparently it works fine when I had a technician look at it.



The monitor has a 2 port connection, 1 for the VGA monitor connector and the other is a 15 pin connector.



There are currently only two wires to the 15 pin connector and I did not have 110v to those wires. Looks like either pins 9,10 or 6,7 have the wires connected to it.



Is the correct for the 110v? or does the power go somewhere else into the monitor and I am just not seeing it?



There is a 3 pin power cord laying loose that is not connected to anything that has 110v to it....

grnd/sync/blue/green/red

dem/dem/----/110/110

----/-----/----/----/----



so as you can see your 110v ac supply wires are cut,that why it not work

What is DEM?



Also are the 110v the only wires necessary to be working for this monitor?





BTW - Grantspain, I tried to contact you on Arcade Otaku. Your exactly the man i was looking for!!!



Thanks!!!!!

K, got the monitor back up...



Now I have this problem. Picture is reveresed and also the picture is not fully spread out over the monitor...



See pic below....

Latest wiring connected now...

Now I am lost. According to the schematic, looks like I have all the wires attached. Not sure what to do now.....

Great! I flipped the red/blue leads and now the horizontal is fixed....



Unfortunately the Horiz. Size pod is having no effect when I adjust it. The picture is still about half the size....