Page 1 of 2
House of the Dead 2 - in standard Naomi Motherboard...
Posted: Fri Feb 04, 2011 8:48 am
by OldFoo
I am getting a House of the Dead 2 setup sent to me. The complete guts. Now can I use the "cart" in a standard Naomi System 1 motherboard or does it need to stay in its barebones stripped down metal case motherboard?
I will be getting the full case, but if I could use the cart in a standard motherboard that would be nice and space saving.
Posted: Fri Feb 04, 2011 9:01 am
by OldFoo
Yes you can use the cart in a standard Naomi.
But you need to change also the Eprom Bios, because house of the dead 2, uses a special Bios.
You can extract the Eprom bios, from the metal cage, and swap it with the Bios on the Naomi Motherboard, or make a copy of the bios if you have an eprom programmer.
Posted: Fri Feb 04, 2011 9:56 am
by OldFoo
HOTD2 will only work on the older style mainboards, the newer type the game will not function correctly.
Posted: Sat Feb 05, 2011 3:09 pm
by OldFoo
If I use the full older style motherboard can I use a Capcom I/O ?
I am trying to save space...
Posted: Sat Feb 05, 2011 3:21 pm
by OldFoo
moloch wrote:If I use the full older style motherboard can I use a Capcom I/O ?
I am trying to save space...
You'll need a dedicated Sega JVS I/O Board, and an IR Type 2 gun board, and IR Type 2 guns to play this game.
Posted: Sat Feb 05, 2011 3:28 pm
by OldFoo
I am getting the gun I/O board in the deal and I am hoping the JVS I/O as well.
It will not work with a Jamma I/O?
I was hoping to put this in a Jamma cabinet that I have. Do I need to convert the whole cabinet to JVS then?
Posted: Sat Feb 05, 2011 3:30 pm
by OldFoo
The guns and bezel are part of the deal as well.
Posted: Sat Feb 05, 2011 5:06 pm
by OldFoo
moloch wrote:I am getting the gun I/O board in the deal and I am hoping the JVS I/O as well.
It will not work with a Jamma I/O?
I was hoping to put this in a Jamma cabinet that I have. Do I need to convert the whole cabinet to JVS then?
Might work with a Sega Jamma JVS I/O, but certainly not Capcom.
Posted: Sun Feb 06, 2011 12:37 am
by OldFoo
AndyGeezer wrote:
Might work with a Sega Jamma JVS I/O, but certainly not Capcom.
The Maze of the Kings standard cab(US) comes with Sega Jamma JVS I/O, so it should work. Grab MoK's standard wiring diagram from
http://www.segaarcade.com/pdfs/mazeofki ... iagram.pdf to see how to wire it up.
Posted: Thu Feb 10, 2011 8:28 pm
by OldFoo
I have a confidential mission cab. Is it the 1st naomi version on it?