Hi,
I bought a new I/O from a fellow user of the forum, and while the analogue inputs seem to work fine, I can't get the board to say a digital button was pressed. I'm not using any cabinet, just the pinout's from Andy's website.
I've tried wiring P1's start to ground and 5v but nothing makes the input change.
Any help much appreciated.
Thanks,
Naoki
Sega I/O Type 1 Digital Inputs won't activate
Thanks Andy, got the inputs to work I guess #1 is a sense pin.
Anyway, while doing experimenting with that, my Naomi was glitching the graphics. It stopped after wiring the I/O right, but it did it even when the I/O board wasn't connected. It only did it on black+white stuff as colour wasn't affected much.
Like I said, it's stopped doing that but should I worry about this?
Anyway, while doing experimenting with that, my Naomi was glitching the graphics. It stopped after wiring the I/O right, but it did it even when the I/O board wasn't connected. It only did it on black+white stuff as colour wasn't affected much.
Like I said, it's stopped doing that but should I worry about this?
NaokiS wrote:Thanks Andy, got the inputs to work I guess #1 is a sense pin.
Anyway, while doing experimenting with that, my Naomi was glitching the graphics. It stopped after wiring the I/O right, but it did it even when the I/O board wasn't connected. It only did it on black+white stuff as colour wasn't affected much.
Like I said, it's stopped doing that but should I worry about this?
Looks like one of the rams is on the way out..