Sega-Naomi

I currently have an Alien VS Predator cabinet and was hoping to get a Naomi system running in it. I was planning on using a Capcom I/O and the existing CPS2 power setup. I've heard of the possibility of power problems if I decide to add a GD-ROM setup later.



I really don't want to run two separate power supplies in the cab and I've read that I wouldn't need two if I used the Capcom I/O. Can anyone confirm or deny any problems I may encounter?



Thanks

Well, you are right. Running a N1 from a Capcom I/O is fine. Adding the GDROM drive is where is becomes tricky. We strongly recommend not running it all from the Capcom I/O.



You could run the GDROM drive directly from the PSU if it allows for easy modding



Welcome to Sega-Naomi, btw

I guess I'll cross that bridge when I come to it. Thanks

So, let me make sure I got this straight...



For the mean time, running without the GD-ROM setup, I would just hook up the 8 pin power connector from the Capcom I/O to the Naomi board and when I add the GD-ROM, I would disconnect the 8 pin connector from the Capcom I/O and connect it and the 6 pin connector directly to a Sega power supply...right?

That's pretty much all there is to it. :smt045