wiring naomi 2 to sega i/o board
Posted: Thu Jul 07, 2011 2:48 am
Hi all
based on this wiring diagram
http://www.sega-naomi.com/resources/manuals/NaomiWD.pdf
the sun psu connects to the CN6 pins of the i/o board and no power comes from the jamma harness
1. Is this the only way, or can power be supplied through the jamma harness instead (ie power comes from one or the other but not both)
2. Are there cables I can buy with the plugs needed to connect to the sun psu (fat rectangle with 8 holes) and the CN6 pins (skinny 6 pin similar to the GD-rom power connector)?
3. Or can I make them myself? Where can I get those different plug shapes?
based on this wiring diagram
http://www.sega-naomi.com/resources/manuals/NaomiWD.pdf
the sun psu connects to the CN6 pins of the i/o board and no power comes from the jamma harness
1. Is this the only way, or can power be supplied through the jamma harness instead (ie power comes from one or the other but not both)
2. Are there cables I can buy with the plugs needed to connect to the sun psu (fat rectangle with 8 holes) and the CN6 pins (skinny 6 pin similar to the GD-rom power connector)?
3. Or can I make them myself? Where can I get those different plug shapes?