Hi all,
I just picked up a House of the Dead 2 cabinet and am having a problem. I have read some of the model 2 gun threads but I'm hoping someone could give me some specific tips for troubleshooting.
Here is the issue:
The gun hooked up on the player 1 side will only register shots erratically. It will usually read as pointing off screen unless aimed at the very middle of the screen. When aimed at the middle the screen the cursor (in gun check mode) is jumpy and erratic.
Player 2 side works flawlessly.
Here's what I have done so far:
When the guns are swapped the problem persists on the player 1 side; it do not follow the gun.
All the IR lights are lit and bright when checked with a digital camera.
What is the next step? Suggestions?
Any help is greatly appreciated.
Thanks!
HotD2 gun adjustment problem
thechop wrote:Swap the guns over at the gun board ( not just at the connector points)to eliminate the cabling being at fault same results will show the board to be most likely at fault.
I'm not sure I follow you. I'm a naomi noob so forgive me. When you say swap at the "gun board" not the "connector points" do you mean
connector points = the larger blue and red connectors?
I swapped the guns at the connector (small white) running to the gun i/o. This should eliminate the possibility of wiring trouble?
Also:
What is the going rate for a gun i/o board and is there anywhere to source them anymore other than forums or ebay?
Thanks!