Sega-Naomi

Hello,

I'm new here, and I've just purchased a nice Naomi cab!

I've lurked the forum for a while, and after seeing many cool projects in here I decided to go as well for this beautiful cab.



I don't really have any JVS experience, so forgive me if this sounds dumb...

my cab came with Virtua Strikers 3 and 2p3b, but I would like to change that and make it a 6 buttons for each player.



I've seen on another post that I need this:

http://www.giz10p.co.uk/Cabinet-Parts/W ... od_85.html



but I'm wondering where it should be plugged. Below pictures of my I/O device









Uploaded with ImageShack.us





Uploaded with ImageShack.us





Hope you guys can advice me on what to do, and if I need additional wires.

Thanks a lot

Hi you need a kick harness and it goes in the white plug to the right of the yellow plug.



John

Morrigu99 wrote:Hi you need a kick harness and it goes in the white plug to the right of the yellow plug.



John

thanks for the reply John!

any advice on where i could get one of those kick harnss?



By the way, what are the three plugs below the p1 and p2 cables used for?

Hi check out Andy geezer at sega shed or Craig at giz10p both have these cables. I think the other plugs are for analogue controls ( trackball steering wheels etc....)



John

Unfortunately they are out of stock in both sites



After reading in the product details of the extra button loom on Segashed the following:

"Although the plug is a 10pin AMP connector, it plugs into the 15pin AMP connector on UK Naomi's.".

I was wondering if they might refer to the one I have in the lower part. If that would be the case I wouldn't need to get the whole kick harness and just the loom right?