Hi all,
i have the yellow Lindbergh with "Lets go Jungle" game.
From some months i get the error 11 "JVS board is not connected to main board"
I have cleaned all the connectors.
I cleaned the JVS card in the Lindberg and the controller.
I have changed the USB cable.
It was OK for two weeks, and gave that error again.
A review all of the above, and cleaned again.
It was ok for a week, and gave that error again.
Please tell me some idea, because it drives me crazy!
Thanks in advance!
Best regards,
Dani
Lindbergh JVS I/O error 11
overclock wrote:If possible,can someone sell the kit about Let's go jungle
Kit included:
1.Lindbergh MB
2.PSU
3.Gun Fuse Sensor Board(include LED board)
4.Gun Assy
5.I/O Board
6.DVD ROM Driver
7.Wiring Harness
8.DVD & Keychip
Thanks!!
Let's go jungle is not Gun Sensor like the gun games, it's analogue pot stick guns.
Also remember the guns are ?1200 each new, so I don't think it would happen unless you fabricate something yourself.
AndyGeezer wrote:Error 11 is to-do with the JVS I/O board, outside of the Lindbergh.
Thank you!
Some news about my problem.
After my last visit to the console i found that somebody before me was connected the 5V power cable in CN8 (5Vout), so i connected it to the CN7 (5Vin)
After that the console was ok for 12days, and gave that error again.
Is it possible the JVS board to be damaged because of that wrong connecting?
Should i replace the whole JVS board, or only the big chip on it?
Re: re
ctamatko wrote:Hello again!
I replaced the JVS card with a new one, but it gives me the error 11 again. :smt017 :smt013 :smt009
I found that the motors for the feedback in the guns are not connected, so is it possible to be from there???
Problem with Let's go jungle, is the gun motors will ripple back and take out the I/O board so many operators disable the gun motor, also the coin lamp can take it out when it shorts.
Also you replaced the I/O card, not the PCI card?