CP Button Connector Question

OldFoo · Post by **OldFoo** » Wed Sep 17, 2008 5:10 pm

I searched around for a bit before asking, cause I know A LOT of connectors have been covered, but couldnt find this one so here goes...I am looking for the single pin quick disconnect style connectors used on the sega button harnesses like on a blast/astro/naomi cp

They are the same ones in this pic:

http://triplemoonstar.brinkster.net/seg ... ockid=2037

Thanks.

OldFoo · Post by **OldFoo** » Wed Sep 17, 2008 6:36 pm

AMP UP 12pin connector

http://triplemoonstar.brinkster.net/seg ... ockid=1779

AMP Pins

http://triplemoonstar.brinkster.net/seg ... ockid=1771

5pin JST NH Connector

http://triplemoonstar.brinkster.net/seg ... ockid=1808

NH Pins

http://triplemoonstar.brinkster.net/seg ... ockid=1781

If you mean the fast-on connectors, then they are a lot easier to come by.

You need 4.6mm ones for japan type buttons, the Happ controls needs the larger 6.4mm jobs.

OldFoo · Post by **OldFoo** » Wed Sep 17, 2008 7:25 pm

Yea I meant the fast-on connectors, japan style, my blast city cp is 12 button, but only wired with a harness for the 3buttons for each player, so I was gonna wire up the others but didnt know who made the quick-on connectors JST or someone else....

Edit: This is what I could find, they say 4.75mm am I in the right direction, or do I need 4.6mm for sure?

http://catalog.tycoelectronics.com/TE/b ... 1-480435-0

OldFoo · Post by **OldFoo** » Wed Sep 17, 2008 8:10 pm

Hate to argue with the geezer, but I believe what you need is 0.110" (2.8mm).

Sanwa part number AT-110, and SR-110 for the sleeves.