Error 01

OldFoo · Post by **OldFoo** » Sat Oct 21, 2006 1:25 pm

Hi,

i have a Naomi 2 with GDROM unit that is connected with a Capcom IO Board.

On startup i get error 01.

In test mode i only see rom board although a dimm board is connected.

What can be the cause of the error, not enought power ?

George

OldFoo · Post by **OldFoo** » Sat Oct 21, 2006 3:29 pm

Faulty rom board, I'd check the pins on both the N2 and the rom board (in your case dimm bd).

OldFoo · Post by **OldFoo** » Sat Oct 21, 2006 3:53 pm

AndyGeezer wrote:Faulty rom board, I'd check the pins on both the N2 and the rom board (in your case dimm bd).

This could be, but I would make checks before declaring anything dead. What is the bios version you are using? Also, does it give you the same error when you use carts?

OldFoo · Post by **OldFoo** » Sat Oct 21, 2006 6:20 pm

Error 01 is normally faulty rom board, or not installed correctly rom board

Error 02 is normally BIOS related

Ideally you need to check it with a regular cart.

OldFoo · Post by **OldFoo** » Sat Oct 21, 2006 6:45 pm

My Bios Version: EPR 23605B

A Game ROM Board is working without problems.

OldFoo · Post by **OldFoo** » Sat Oct 21, 2006 9:00 pm

You have the right BIOS for a dimm board, so I'd say you have a faulty dimm board sadly.

OldFoo · Post by **OldFoo** » Sat Oct 21, 2006 11:12 pm

That would be unfortunate. Did it work before? If so, perhaps the memory dimms might need to be reseated.

(I'm not much of a pessimist

)